FUJI AS-Interface_AS-i Accessories Addressing unit

Incorporates versatile new functions compatible with version 2.1.

.	In addition to conventional address setting functions, this unit makes it possible to read the addresses of slaves on the AS-i line and the I/O data of the slaves.
.	Address settings can be made for standard slaves and A/B slaves.
.	Address settings can be made for slaves provided with an addressing jack (e.g., FM6D 1, FM4D, FM2D1, and FM1D slaves) over an address setting conversion cable (FX9Y002).

FL1HA-E
(KK04-008)

Type	FL1HA-E
Operating temperature range	0 to 40˚C
Storage temperature range	–20 to 40˚C
Display	LCD
Control key	Flat key (Numeric 5-key pad)
Degree of protection	IP20
Power supply	Built-in secondary battery Charging time: Approx. 14h (with provided battery charger)
Secondary battery life	Addresses can be read or written approximately 250 times with a full charge. If the battery is charged and discharged for a maximum of 500 cycles, the number of possible address reading and writing times will be gradually reduced by the battery memory effect.
Battery charger	Provided
Adressing cable	FX9Y002 (sold separately)
AS-i specifications	Version 2.1 compatible

Key display	Function
ADR	Reads the addresses of connected slaves. The power will be automatically turned off if no operation is made for approximately one minute or more.
PRG	Writes addresses to connected slaves.
MODE	Selects operating modes.
	Selects and subtracts addresses or data.
	Selects and adds address or data.