FUJI AS-Interface_AS-i Masters DeviceNet/AS-i gateway

The DeviceNet/AS-i gateway converts data between the open network DeviceNet and the AS-Interface protocol. DeviceNet was developed and is supported by the Open DeviceNet Vendor Association (ODVA).

.	Up to 62 A/B slaves can be connected.
.	Up to 31 analog slaves can be connected.
.	Addition of notification function of peripheral error.
.	Being upward compatible with the conventional FC2L-DL conforming to AS-i specifications V2.0, replacement is easy.
.	The slaves' configuration can be registered by a pushbutton switch on the front of the gateway.
.	The status of the AS-i bus is indicated by the LEDs on the DeviceNet/AS-i gateway, e.g., showing disconnection of slaves, AS-i power supply failure, and automatic addressing availability.
.	The 7-segment LED indicates the addresses of disconnected slaves (in protected mode) and configured slaves (in configuration mode).
.	AS-i specification: V2.1

FC2LA-DL
(KK03-044)

General specifications

Type	FC2LA-DL
Insulation resistance (Communication sections excluded)	10M or more with 500V DC megger, between external terminals connected together and FG
Dielectric strength (Communication sections excluded)	445V AC for 1min, between external terminals connected together and FG
Operating temperature	0 to +55˚C (no icing or no condensation)
Storage temperature	–20 to +70˚C (no icing or no condensation)
Relative humidity	20 to 90% RH (no condensation)
Pollution degree	Pollution degree 2 (no conductive dust)
Atmosphere	No corrosive gases and massive dust
Vibration resistance *	Amplitude: 0.15mm Constant acceleration: 19.6m/s² for 2 hours in each direction
Shock resistance *	294m/s² destruction threshold (Peak acceleration)
Noise immunity	Noise simulator method: Rise time 1ns, pulse width 1μs, 1.5kVp-p
Electrostatic discharge resistance	Contact discharge method: ±6kV, Aerial discharge method: ±8kV
Degree of protection (IEC 60529)	IP20 (installation inside panel)
Mounting method	IEC rail/screw dual mounting
Cooling method	Natural cooling
Mass	Approx. 320g
Approval	CE

Note: *

Resistance where the DeviceNet/AS-i gateway is screw-mounted. Less vibration and shock are permitted when IEC rail-mounted.

DeviceNet communications

Applicable DeviceNet specification		Release 2.0
Power supply for communication		24V DC (operating voltage range: 11 to 25V DC)
Current consumption		80mA or less
Type of node		Group2 Only Server
Vendor ID		0x13F (Fuji Electric)
Device type		Communication adapter (Code: 0x0C)
Station number setting (MAC address)		64 stations with numbers from 01 to 63, but no overlaps of number
Cable length	Transmission speed	500kbps	250kbps	125kbps
	Trunk line Drop line Total drop line	100m 6m 39m	250m 6m 78m	500m 6m 156m
No. of message connection No. of I/O connection		1 (Pre-defined master/slave connection set) 1 (Polling)
No. of Transmission data (fragmentized)		8/16/32/26/42 bytes (Mode 0 to 4 changeable)
No. of Receiving data (frgmentized)		8/16/32/26/42 bytes (Mode 0 to 4 changeable)
Cable		Dedicated DeviceNet cable

AS-i communications

Maximum connectable slaves	62 A/B slaves for V2.1 (addresses 1A to 31A, 1B to 31B) 31 standard slaves for V2.0 (addresses 1 to 31, Analog slaves /standard slaves.)
Maximum No. of input/output points	434 points (When connecting A/B slaves: 248 input and 186 output points) 248 points (When connecting standard slaves: 124 input and 124 output points)
Network topology	Tree, line, and star structure
Maximum cable length	Up to 100m (extendable up to 300m via Repeaters)
Transminssion speed	167kbps
Transmission cable	AS-i cable (yellow) or parallel cable (2 x 1.5mm²)
Cycle time	Approx. 10 (5) ms (with 62 (31) slaves connected)
Power supply for communication	AS-i power supply (30V DC)
AS-i current consumption	120mA or less